The original V400 Speeder Pad Ajustable Arm Mount is a wonderful addon to the printer, but the frame mount doesn't work anymore if you made custom enclosure which used all side slots on the frame. So I made a new frame mount, that you can install on one of three feet.

Hardware requirement:

M3 x 15 bolt x4

M3 hex nut x4

Installation:

1. Clear the bottom of the frame foot that you want to install the mount on, take down the rubber feet
2. Insert hex nuts to the Nuts Base
3. Insert the pair of the Nuts Base inside the frame, align all four screw holes to the frame's
4. Route the Speeder Pad cord through the bottom cord passthorugh on the mount body
5. Put on the mount body to the frame and fasten with four M3 bolts through 4 holes
6. You need to mirror one of the small arm (arm 2) in order to mount the holder in correct orientation,