BBL Simplest Poop Chute

BBL Simplest Poop Chute

Boost
17
44
3
GIF

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

ASA, 0.16mm layer, 2 walls, 15% infill with supports
ASA, 0.16mm layer, 2 walls, 15% infill with supports
5.4 h
1 plate

Boost
17
44
3
2
53
13
Released

Description

A 3D printed poop chute that doesn't require extra hardware or magnets. The BBL Simplest Poop Chute utilizes ONE secret screw that is longer than the others that is already on the back of the unit. This allows the poop chute to just hang on the back of the unit for easy removal and disposal of filament. See pics for instructions. (I noticed this on my P1P printer, not sure if it applies to every P1P printer or other models)

Note: Use a H2.0 Hex key to remove screws and you'll notice that one screw is a coarse thread and the other is a fine thread. This did not affect my installation.

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Boosted
Would it matter if I print with pla or petg?
The designer has replied
1
Reply
Does not matter.
0
Reply
Boosted
Used one of the screws from shipping which secures various parts in the unit. Probably would benefit from a top and bottom screw point to ensure it doesn't sag away from the back of the P1S.
1
Reply
No more