***I was unable to load the print profile, as being a very detailed model, it takes a long time and is not accepted by the system. I then uploaded the file with all the settings as RAW (3mf) differently so that it can be downloaded and launched from Bambustudio***
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.9mm
Filaments Used:
PLA Generic Black Transmission Distance: 0.3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA Generic White Transmission Distance: 6
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Gray
At layer #15 (1.28mm) swap to Silver
At layer #19 (1.6mm) swap to White for the rest.