Snap in Rod Holder
Copyright Claim
Snap in Rod Holder
Boost
17
25
9
GIF
GIF
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
58 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Boost
17
25
9
3
15
11
Released
Description
Been wanting to make a fishing rod hanger for the garage door for a long time. Finally got around to doing it. Holds up in East TN weather using PETG pretty good and stays snappy. Hope you guys like it. gif was added to show assembly :)
Comment & Rating (9)
All
What type of spring are you using and where can they be purchased?
The designer has replied
0
Reply
it's a printed spring.....petg is recommended
0
Reply
Replying to @thamitchsta
is printing it using PLA an option?
0
Reply
you could, my garage would get hot and the spring would loose some springyness
0
Reply
how do I fix the lid? I'm not holding up... it is better to provide a connection on small bolts. I would loosen the spring so that the rod fits easily.
The designer has replied
0
Reply
if you scroll on the photos I have an assembly gif. as for the spring, maybe heat it up a little bit and bend it in?
0
Reply
Boosted
Awesome model
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
how do I fix the lid? I'm not holding up... it is better to provide a connection on small bolts. I would loosen the spring so that the rod fits easily.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld