I wanted my holster to be easy to print with little to no post processing. After a few versions I realized I also needed the belt buckle area able to print clean with no supports required so as not to scratch up my belt. This model was made to specifically print standing up utilizing a small brim so that no supports are needed for printing. 

This has been pretty handy as an easy way to keep my rod/reel off the ground/sand/beach while swapping lures and being able to use two hands in removing stubborn hook sets. I also wanted it to be angled forward just enough to keep the rod usable and/or out of the way while it's holstered.

Hope you enjoy and tight lines!

------------------------------------------------------------------------------------

V2 released with Waist Clip - No Belt needed! 

https://makerworld.com/en/models/494357#profileId-408308