Five Crowns Deck Box
Remixed by
Copyright Claim
Five Crowns Deck Box
Remixed by
Boost
2
4
3
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
2
4
3
0
7
6
Released
Description
Increased the width of the lid by .25mm.
May not seem like much, but the prior lid was loose and could be removed without sliding out.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Printed in eSun PETG. ran out of black halfway and ended with white, but still looks good. luckily had the switch where the top groove is so it looks purposeful. fits loose until the cards are inside. would be awesome to have a version with magnets to hold the lid shut.
The designer has replied
0
Reply
Kind of a fun look!
0
Reply
My original file is meant to be used with a full deck and the instructions, which creates pressure to keep the lid in place.
0
Reply
No more
This remix is based on
The model does not exist anymoreLicense
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld