Bed reinforcement brackets for the Ender 5 and Ender 5 Pro in order to reduce vibrations and make the bed more stable.
Advantages over other models:
Material: because parts of brackets are close to the heated bed I highly recommend using a heat resistant filament like PETG or better. I used PA CF15.
Orientation: rotate the parts 45 degree and print them like this:
Settings: min 4 perimeters (for 0.4mm nozzle), 25%+ infill, no supports, infill angle 0 (very important!).
Use a drill or a screw to break the holes.
BOM for 2 supports:
IMPORTANT: don't over tight. You can damage the bearings and the smooth rods!
After installation verify if your Z works smoothly.
Use a zip tie to secure the brackets to the bed frame.
UPDATES
19.08.2023 - Change the radius for bearings from 10.00mm to 9.70mm