A1 Base Cable Cover by Ocular Dynamic

Ocular Dynamic

3D Printer>3D Printer Parts

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

37 min

1 plate

4.6(9)

0.2mm layer, 2 walls, 10% gyroid infill

33 min

1 plate

4.0(2)

Open in Bambu Studio

Boost

Released

Description

I didn't like how the 3 little plugs on the bottom of the A1 were exposed after assembly so to make it look a little cleaner (even though you wont see it on the bottom) I decided to make a little cover that like slide in to place to cover them up. Super easy print, press in place.

Check out my Z Motor Dust Cap Here or my Turbo Fan Shroud Here

Comment & Rating (22)

@recitationalpri

Print Profile

0.2mm layer, 2 walls, 15% infill

very good, time-lapse caused minor deformations, but that's normal.

The designer has replied

@OcularDynamic

I don't tend use time-lapse so i'm not familiar with the deformation it can cause. But if thats normal, here's hoping for a 5 star review =]

@recitationalpri

I actually replied before I installed it, but the cover actually pushes my extruder source input usb-c cable out of the slot and disconnects the extruder. not going to lower the rating since I did have timelapse on which probably put a bump somewhere.

@Jacopo_0123

Print Profile

0.2mm layer, 2 walls, 15% infill

il modello mi ha scollegato il capo type c e non funzionava più la stampante

The designer has replied

@OcularDynamic

Did you happen to have timelapse on? I'm wondering if thats causing some sort of issue as it only seems to be present for those using timelapse

@Jacopo_0123

Replying to @OcularDynamic :

la stampante non riusciva più a livellare, pensavo fosse un problema di hot end e invece togliendo la protezione è tornata funzionante

@OcularDynamic

Replying to @Jacopo_0123 :

Interesting, I can't seem to replicate the issue. I just slid it in to place and have been printing non stop for the last month with no issue. It doesn't touch anything but the base plastic of the machine to hold it in place so I'm not sure what is happening in your case, or if theres an unaccounted variation in your machine from mine as sometimes thats possible.