Print-In-Place Finger Skateboard V2 -Bigger Wheels

Print-In-Place Finger Skateboard V2 -Bigger Wheels

Boost
11
13
2

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

Normal Settings 0.2mm layer, 2 walls, 15% infill
Normal Settings 0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate

Boost
11
13
2
0
12
15
Released

Description

This is version 2 of one of my most popular models. This version 2 has the following:

  • Bigger Wheels for better rolling
  • Smoother rolling interface
  • Sloped overhang for easier printing

This is a Print-In-Place finger skateboard or fingerboard. This is similar to a Tech Deck but a lot cheaper. This skateboard is fully customizable.

Print Settings:

Layer Height- 0.2mm

Infill- 15%

Brim- Yes, outer brim only, brim width 10, brim- object gap 0.1

Supports- no!

Printer- Any printer

Grip Tape (Electrical Tape)-

This is not required but will make the skateboard much better.

Link to electrical tape- https://a.co/d/5ivgqha

Here is a video I made showing how to clean up your skateboard and add the grip tape This should still work with the new version just fine! (includes specific measurements of sizes of pieces to cut off electrical tape)

Support my shop at https://fin3dprinting.etsy.com

see my YouTube channel at https://www.youtube.com/channel/UCr6vlDZr5RTa7Ya1-jMhi8w

My Patreon Here (commercial use) https://patreon.com/Fin3dPrinting?utm_medium=unknown&utm_source=join_link&utm_campaign=creatorshare_creator&utm_content=copyLink
Thankyou!!! Happy printing!!!!

 

 

 

Comment & Rating (2)

Please fill in your opinion
(0/5000)

You did not mention how to orient the model on the build plate. Assuming its supposed to be on its long side so 2 of the wheels touch the plate?
The designer has replied
1
Reply
yes. I will verify that in the description! good luck printing it! hope you like it!
0
Reply
No more