Silica Box Funnel
Remixed by
Copyright Claim
Silica Box Funnel
Remixed by
Boost
9
13
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Boost
9
13
7
5
17
8
Released
Description
Getting silica beads in the silica box wasn't as easy as I wanted so I created this funnel lid for the silica box.
Slides on just like the lid and stays in place while loading the box.
The opening is a bit on the small side but a little shake and the beads fall in.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Makes refiling much easier, but the gap could be slightly bigger. I assume its for the strength, nonetheless nice print, thanks for sharing :D
The designer has replied
0
Reply
Yes, it could be adjusted a little bit. It just didn’t bother me enough to take the time to adjust it yet. Thanks for positive review!
0
Reply
Отличная модель! Спасибо!
The designer has replied
0
Reply
Thank You!
0
Reply
Boosted
Very useful.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank You!
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld