3 Lead ECG cable organizer

Copyright Claim

3 Lead ECG cable organizer

Boost
3
5
2

Print Profile(0)


Add the first print profile to earn points

Boost
3
5
2
0
2
0
Released

Description

This very simple model is similar to the original cable organizer provided by manufacturer of ECG machines, but for me this is a better mechanism than the one provided from factory (the original one broke after a while). It relies on sliding two parts against each other and then securing it with a piece of filament (approx. 6mm long, hole cutout is for 1.75mm filament). You can choose yourself if you want to print it with or without the heart symbol.

 

Recommended print settings:

  • 0.20mm layer high
  • 100% infil
  • no support needed
  • (I used classic PLA)

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Having had the same problem with lead separators, I too had to make one. My device uses 4 cable, and the vendor one was absolute cheap garbage. Take a look at the one I put together, it uses a print-in-place hinge and latch system for easy removal and reapplication. Might be worth combining with your design! https://makerworld.com/en/models/433964#profileId-338752
The designer has replied
0
Reply
Thank you very much, definitely will take a look at it!
0
Reply
No more