Gridfinity with pin USB A storage
Remixed by
Copyright Claim
Gridfinity with pin USB A storage
Remixed by
Boost
0
3
2
Print Profile(1)
0.2mm layer, 2 walls, 13% infill
Designer
25 min
1 plate
Boost
0
3
2
0
4
3
Released
Description
Sliced off the bottom of a gridfinity USB storage design and added the bottom of the gridfinity with pin instead to make it compatible. Note that the USB sticks are not a tight fit but have a little slack so they go in easily.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 13% infill
Tight fitting would have been better.
The designer has replied
0
Reply
I have this deep in a drawer system so found it easy to remix a model with a bit of play to actually get them in easily but I see your point, I'll add a comment to say it's a slightly loose fit to make that clear. Appreciate the comment
(Edited)1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld