Hi I was looking for a gift for my girlfriend that loves Winnie-The-Pooh so i created this image with Hueforge.

The gift was a bit success!

I love how adorable and cute it turned out.

More available on my page:

Disney collection: https://makerworld.com/@user_3714247037/collections/1362679

Filament used:

PLA Jayo Black Matte TD:0,3

PLA Eryone Jade White TD:8

Use a white that doesn't fill to fast to get a better gradient, so generally cheap filaments are better.

To use it without AMS:

• Use the normal profile
• Slice the profile
• On the right go to layer 6
• Right Click > add Pause > Ok
• This will Trigger a manual Pause at this Layer where you can then change the filament

Enjoy!

If you need an easy stand for the picture you can use this:

It only uses 17g filament and is printed in 37 minutes 

https://makerworld.com/en/models/470314#profileId-379805