Search models, users, collections, and posts
Remixed Clips and Plug for LED Riser Modular
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
23
72
19
1
144
94
Released
Description
Made some small remixes.
The plug received a cable hole, so I can route the usb cable to the outside, and still plug the hole.
The small clamps got modified, so there is now a little piece to lightly press on the led strip.
I had the problem that the adhesion of the strip wasn't so good one some part. And i reduced the width to 5mm from 10mm.
I removed infill and top/bottom surfaces. And printed with 1 and 2 walls.
With 1 wall was very light and flexible, but still resistant. It was holding well, but the upper part was a bit to flexible for my taste.
So I used the one with 2 walls, which was just perfect. Solid fit and very good grip.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (19)