Stackable Bottle Holder PARAMETRIC by capze.

capze.

Household>Other House Models

Print Profile(4)

All

P1P

P1S

X1 Carbon

X1E

0.28mm layer, 3 walls, 15% infill

Designer

4.1 h

1 plate

4.8(22)

0.28mm layer, 3 walls, 15% infill

Designer

2.8 h

1 plate

4.8(5)

0.28mm layer, 2 walls, 15% infill

Designer

1.4 h

1 plate

5.0(3)

connectors PLA 0.28mm layer, 2 walls

Designer

16 min

1 plate

3.7(3)

Open in Bambu Studio

Boost

179

364

328

447

Released

Description

I designed this model to be able to store stuff without having to worry that it will collapse under its own weight.

Some improvements are:

Easier connections between parts
Some overhang support for a cleaner print
A top flat plate
how about that it is parametric?

Printing

You can either:

download the STLs (it will fit wine bottles)
“change parameters” in the Fusion 360 file to suit your own needs.

Does not need supports.

Assembly

Assembly is easy, should work even if your printer is not calibrated.

The connector goes somewhere on the crosses, I suggest using a few depending on height.

Note: This is not a remix, thank you for the inspiration.

Comment & Rating (44)

@msa1906

Print Profile

0.28mm layer, 3 walls, 15% infill

print good

(Edited)

@msa1906

Replying to @capze. :

my bad just saw it

(Edited)

@bollekeil

Print Profile

0.28mm layer, 3 walls, 15% infill

Overhangs didn't come out very clean. But I was really amazed at how much filament was needed! It's probably supposed to be sturdy, but I felt like it was overkill. I thought I could do it with some leftover filament. But then it brought two remaining rolls and a third. Unfortunately it ended up in the trash afterwards because I chose a different model. With six holders that would have been way too much filament for me. But you can see the required filament before printing.

The designer has replied

@capze.

Indeed i preferred to make it strong, it can potentially be optimized; however, you can whip out your own , you have access to the f3d file

(Edited)

@solomonoff

Great!

@josephlion2015

It is very beautiful and useful!

@dangermouse

@capze. thanks for this model. Awesome. So helpful.

@Andreassbj

Print Profile

0.28mm layer, 3 walls, 15% infill

perfect!!

(Edited)

@user_3825132041

Boosted

Print Profile

0.28mm layer, 3 walls, 15% infill

@schichtwerk3d

Print Profile

0.28mm layer, 3 walls, 15% infill

@Insomniac

great design, but where is the file for the connector clip?I only see the main body and two top options?

The designer has replied

@capze.

you click "Raw model files" and everything is there

@PrettyGoodGatsb

Print Profile

part selectable, 0.2mm layer, 3 walls, 15% infill

Great model, thank you! With this one i actually feel fine stacking full wine bottles, unlike other models I’ve seen. I think 2 walls with .42mm lines is strong enough for my needs and uses about 20% less filament 👍