Card coin holder (for e.g. Lockcard Wallet) by E-buddies

E-buddies

Fashion>Other Fashion Models

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 2 walls, 15% infill

Designer

39 min

1 plate

4.8(4)

0.08mm layer, 2 walls, 15% infill

Designer

39 min

1 plate

4.0(1)

Boost

Released

Description

I didn't like other solutions where I could combine banknotes and coins. It is noisy and annoying to get the coins out of the tray.

So I found an already nice solution from mirabatek but I had difficulties pulling it out of the wallet. So I've created my own with a nice round fillet at the back and flat front for a clean and nice finish. I recommend using a good sliding material like PLA-Metal, which I've used to easily pull out the card without pulling out other cards.

I was inspired by mirabatek but did not use his STL and created my version.

https://makerworld.com/en/models/126202#profileId-136348

Update:

I've made 2nd version with a second hole to pull the card from the bottom as well.

Comment & Rating (6)

@rapidraid

Print Profile

0.08mm layer, 2 walls, 15% infill

I used PETG (cause I want to keep it in my car for emergency coins) and the clearance for the coins are very tight. Don’t know if it’s because of the material or the print. But with some applied force it fits.

The designer has replied

@Ebuddies

Hi, I did not try it with PETG, but I will test it soon as well ;) and modify if necessary. With PLA, it was a bit tight too, but it can wear a bit out after some usage.

@user_2311640713

Print Profile

0.08mm layer, 2 walls, 15% infill

Wenn ich den Halter mit Münzen bestücke wölbst er sich ein wenig, schätze mal weil sie so stramm drin sitzen. Vielleicht weil ich es mit PLA gedruckt hat. Sonst super. Vielen Dank.

(Edited)

@user_1428055043

Print Profile

0.08mm layer, 2 walls, 15% infill

Printed it in PETG, is a nice fit. Four points, because it doesn't follow the design on the edges like original lockcard models, so it just lookes different. A bit unpleasing