TESLA Model Y Rear Seat Hooks with Logo
Copyright Claim
TESLA Model Y Rear Seat Hooks with Logo
Boost
10
42
4
Print Profile(2)
0.2mm layer, 6 walls, 25% infill, PAIR of Hooks
Designer
1.4 h
1 plate
Flat Edges - PETG - 0.2mm layer, 4 walls, 25% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
10
42
4
0
57
35
Released
Description
Tesla Model Y Rear Seat Hooks
with Tesla or Optimus Teslabot engraving.
I originally printed them in PLA and they lasted quite a while , but a 3 day 30oC UK heatwave melted one of them, so reprinted them in PETG.
June 27th 2024 : added a print profile with the Chamfered sides removed to enable easier printing.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 6 walls, 25% infill, PAIR of Hooks
Printed in PETG and prints well
let’s see if it holds
The designer has replied
1
Reply
I used PLA and they seem to be holding up ok so far. Fingers crossed 🤞
0
Reply
Also printed these in PETG. I expect they will do fine and the Tesla seat back will break before these. Thanks for sharing!
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill, PAIR of Hooks
two times spagetti
Bed Adhesion Issue
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld