此为 BoBoInnovation 设计的 Block 26 飞盘发射器的弹匣释放弹簧替换模组，如果你对 Block 26 TPU弹匣释放弹簧手感不满意，那么试试这个。直接替代TPU弹簧零件。

安装方法：

1. 需要一根外径2.5mm，长度10mm的压簧
2. 强烈建议用万能胶将弹簧的一端粘死在零件的弹簧凹槽内。这样将极大简化安装
3. 将弹匣释放按钮插入握把，对齐开口，将粘好弹簧的零件向TPU原零件一样插入。插入时请关注弹簧状态
4. 测试弹匣释放按钮是否正常回弹。若安装不正常，请拔出零件，重新尝试安装。重点在于弹簧对位

本模组得到 BoBoInnovation 的授权免费开放下载，请尊重CC-BY-NC-SA协议使用（署名-非商用-以同样方式共享）。

如果你还没有 Block 26，图纸购买请到B站搜索 BoBoInnovation勃勃，寻找工房购买链接。

------------------------------------

This is compression spring mod for the mag release of the Block 26 disc shooter by BoBoInnovation. If you also feel the mag release with the original TPU printed spring uncomfortable to use, try this mod instead. Replacing the stock ‘Mag Release Spring’ part.

INSTALLATION:

1. You need a  small compression spring with 2.5mm in outer diameter, 10mm in length
2. Highly recommended to glue one end of the spring to the destinated place on the part, it eases the following assembly a lot.
3. Place the mag release button into the lower grip, align it in place. Then insert the part with the spring glued on, like the original TPU part. Beware of the position of the spring while inserting.
4. Test if the mag release works. If not, remove the part, and install again. The key is to keep the spring in place.

This mod is authorized by BoBoInnovation to release under CC-BY-NC-SA licsence.

If you want to play with the Block 26, please wait for its official release outside China.