print in place Magnetic cable holder by Timo

Timo

Household>Other House Models

GIF

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 4 walls, 15% infill

Designer

41 min

2 plates

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Printed with 0.2 mm layer height. Distance of the folding mechanism is 0.2 mm. The holder is mounted with double-sided adhesive tape or with 2 wood screws. The magnets are pressed in. If they do not hold glue them in place with some superglue.

Magnets: 2 x 6mm x 2.5mm
Screws: 2 x 3mm diameter, maximum screw head diameter 6mm.

**************************************************************************************************

gedruckt mit 0.2mm Schichthöhe. Abstand des Klappmechanismus ist 0.2 mm. Montiert wird der Halter mit doppelseitigem Klebeband oder mit 2 Holzschrauben. Die Magnete werden eingepresst. Falls sie nicht halten mit etwas Sekundenkleber festkleben.

Magnete: 2 mal 6mm x 2.5mm
Schrauben: 2 mal 3mm Durchmesser, Schraubenkopf maximal 6mm Durchmesser.

Bill of Materials

Bambu parts

D6x2 mm Round Magnet (20PCS) - CA004

B-CA004

× 2

Purchase from Bambu Store

Comment & Rating (2)

@MMG1974

Boosted

Print Profile

0.2mm layer, 4 walls, 15% infill

Printed great! Thanks for creating this!

@MMG1974

Boosted

Just what I was looking for. Printed easy! The only problem I encountered was that holes for the 6mm x 2.5mm magnets were just a bit too small. It might be that my magnets were slightly larger than advertised. I recut the holes in Bambu Studio to measure 0.1mm larger and they fit perfectly, still tight and without glue needed to hold them in.

No more