Hey y'all. I hope you're doing well. I whipped this up as a last minute gift for my mother in law. I used a pig STL by Infalivia on Thingiverse as the main body. I think it turned out pretty well. All I did was tilt the pig back and add a base. The original had a less than ideal bottom surface and required support to print. My version requires no supports and is functional for holding any brand of phone or tablet, even in cases.
Prints without supports. The included 3mf is for PETG at 0.12mm Layer heights. If you upscale or print at a larger layer height, support may be required. Feel free to experiment with all of the settings and post your results.
Please like and follow for more remixes and trippy original designs. Be sure to check out my profile to find all sorts of cool stuff.
Thanks for stopping by.