Hello,
This is my Snus holster for everyone. It is completely self-drawn. I hope it brings you joy.

Print Information:

For Part 1, 2 and the Belt Clip you can use any Material you want. (At the picture its made out of PolyLigth PLA black)

The Spacer has to be made out of TPU.

Assembly instructions:
You need 4x M4x25mm countersunk head screws and 4x M4 nuts.

Screws: https://www.amazon.de/dp/B08M5QSKL3?psc=1&ref=ppx_yo2ov_dt_b_product_details

Nuts: https://amzn.eu/d/95toDyL

It is important that the parts are printed correctly so that the support area is not visible. (shown in the picture)

The spacers are slightly larger so that everyone can adjust the pressure with which the Snus can is held.

It is compatible with pretty much every Snus can.

Siberia, Fox, Velo, Scooper Energy, Frosted Thunder

If you have any ideas for improvement, just comment it.

V1: Belt Clip was too weak / now its thicker
V1.1: Now the whole build is sized down to M4 Bols and Nuts/The Front Plate has a longhole, so it can be pushed out easier/ The Spacers are a little bit bigger now you have more control about the pressure/ The Belt clips are smaller
V2: The whole Design is made with countersunk head screws.