Drax from Guardians of the Galaxy created with HueForge. This is a FIVE color print, you wiill need to swap out black with white once the black layers have completed printed. Do this manually on the AMS.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

This print uses 5 unique filaments

Filaments Used:
Hatchbox Black

Hatchbox Red

Creality Brown

Creality Gray

Bambu White

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Red
At layer #10 (0.88mm) swap to Dark Brown
At layer #11 (0.96mm) swap to Gray
At layer #17 (1.44mm) swap to Black (White) for the rest. -------→ In the slicer, this is set to Black. This is where you will need to have white in this physcial slot in order to finish.