Touch pen, pencil for Nintendo DS, 2DS, DSi touch
Copyright Claim
Touch pen, pencil for Nintendo DS, 2DS, DSi touch
Boost
2
5
2
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Boost
2
5
2
0
7
12
Released
Description
Good day,
Welcome to my profile, full of models and miniatures :-)
I'm an Ainon3Dprint model maker and printer
I have here for you a pen, a pencil for Nintendo consoles (Nintendo DS, Nintendo DSi, Nintendo 2DS, etc.). The pen is tested and works great, and it fits the console itself just as well.
Printed without supports
To contact for possible cooperation, please use the email:
If you are interested in my work, the links are here:
https://www.instagram.com/ainon3dprint/
https://www.tiktok.com/@ainon3dtisk
https://www.patreon.com/Ainon3Dprint
Thanks for the support, it's a pleasure :-)
Have a nice day
Comment & Rating (2)
All
I purchased an ESP32 for the Xtouch screen for P1 printer. I lost the touch pen. This is a perfect replacement. The only problem was that printing the pen on its side is hard. First, it didn't stick to the plate. Then, it printed -- I don't know how to describe it -- like it had melted. So, I finally printed it from the end. Just right.
The designer has replied
0
Reply
This should have been printed on a flat surface, as in the print profile
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld