首先感谢 EzyCraft 提供的灵感，First of all, thank you to EzyCraft for providing inspiration.
需要准备的物料：5片蝴蝶纸、5片透明内页、1个上支架、1个下支架、1个底座和拓竹LED Lamp Kit 001。
Materials to be prepared: 5 Butterfly Papers, 5 Transparent Inner Pages, 1 Top Stand, 1 Bottom Stand, 1 Base, and Bambu LED Lamp Kit 001.

装配过程 Assembly process：
1.将蝴蝶纸按折痕折上，顺序如下图左图（图上的零件非本设计的，不过工艺是一样的），注意第2步为把触角掰弯即可，不需要折。折好后的效果如下图最右图。此步骤重复4次，做出5片蝴蝶纸。
1.Fold the Butterfly Paper according to the crease, in the order shown on the left of the figure below (The parts in the picture are not from this design, but the process is the same). Note that the second step is to bend the antennae, without folding. The effect of the finished product is shown on the right of the figure below. Repeat this step 4 times to make 5 Butterfly Papers.

2.取出打印好的5片透明内页，按折痕折弯成下图中间的样子（图上的零件非本设计的，不过工艺是一样的），再将边上的凸点插入蝴蝶纸边上的孔里，两边都插好后就完成安装，此步骤重复4次，做出5片完成版的蝴蝶纸。
Take out the printed 5 pieces of Transparent Inner Pages, bend them into the middle shape as shown in the figure below (The parts in the picture are not from this design, but the process is the same), and insert the bumps on the edges into the holes on the edge of the Butterfly Paper. After inserting both sides, complete the installation. Repeat this step 4 times to make 5 finished Butterfly Papers.

3.将下支架装在底座上，将LED Lamp Kit 001装在上支架上，注意电线卡在卡口上，电线穿过下支架和底座。将蝴蝶纸装到两个支架上，注意上支架的卡口和下支架的卡口要对应上。装完后，把电线卡在下支架的卡口里，再一片一片地装剩下的4 片蝴蝶纸
3.Install the Bottom Stand on the Base and the LED Lamp Kit 001 on the Top Stand, making sure that the wires are stuck in the slots and pass through the Bottom Stand and base. Install the Butterfly Paper onto the two stand, ensuring that the slots on the upper bracket correspond to the slots on the lower bracket. After installation, clip the wires into the slots on the lower bracket and place the remaining four Butterfly Papers one by one.

4..完成安装，通电，尽情欣赏自己的作品吧！
4.Complete the installation, power on, and enjoy your work!