This is a meticulously designed tool holder, intended to fit on the side of a Bambu Lab P1P. I went through 8 different iterations before I was satisfied with the design. I spent way too much time on this model, but I am happy to say, it's as good as I can possibly make it.

The tool holder was carefully designed to not interfere with the printers movement in any capacity. Placement, sizing, profile, and mechanisms were integrated in to the design to ensure redundancy in protecting the printers moving parts from any possibility of collision.

Furthermore, I have designed it as an easy to print, 2 part object that simply snaps together with zero tools, fasteners, or adhesive. It prints with minimal supports needed.

Installation is a breeze. Start by taking the clip, and sliding it on to either the left or right side crossmember frame brace (see pictures). Slide the clip all the way on until it cannot go any further. Next, take the tool holder bucket part, and place it above the inverted dovetail on the clip. Firmly press the bucket downward on to the inverted dovetail until you hear a satisfying “snap”, and the bucket and clip are flush with one another.

The inverted dovetail design choice was made to act as a secure mounting method that requires no tools, fasteners, or adhesive - but would still secure the bucket in both an upward AND downward motion to prevent it from ever shaking loose.