2 versions included. “1” and “1b”. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

If changing size . . . only change X and Y, not Z.

The Model is 156.8x235.2mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.8mm

Filaments Used:
PLA Bambulab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Red Transmission Distance: 4
PLA Gray Transmission Distance: 3
PLA White Transmission Distance: 6

This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #13 (1.12mm) swap to Gray
At layer #17 (1.44mm) swap to White for the rest.

Project: Deadpool 1b.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
If changing size . . . only change X and Y, not Z.

The Model is 200x300mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3.2mm and the Actual Depth is 3.3mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Gray Transmission Distance: 2
    PLA BambuLab Matte White Transmission Distance: 3.5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #9 (0.8mm) swap to Red
    At layer #24 (2mm) swap to Black
    At layer #30 (2.48mm) swap to Gray
    At layer #36 (2.96mm) swap to White for the rest.