I was searching for a birthday present for a chess fan, so I looked for a pen holder. However, I wasn't satisfied with the rook pen holders I found on this website or other 3D printing pages. Therefore, I decided to create my own!

In the picture, you can see that there is enough room for a name tag!

Printparameter: 

Layer height: 0.2 mm
Line width: 0.4 mm 
Walls: 3
Infill: Cubic 10%
Printtime: Around 2 hours

Nametag:
Chaaracter height: 8.50 mm
Bolt

Used Filament: Elegoo PLA+
Used Slicer: Orca 2.0.0
Used Printer: Elegoo Neptune 4 Pro

I hope you like it as much as I do!