Tankard with Lid Remixed by TKB-3D

Remixed by

TKB-3D

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

4.3 h

1 plate

4.2(10)

Open in Bambu Studio

Boost

Released

Description

This is a remix of the Can mugger! it was great and I loved the idea. I figure a lid would make it even better!

Comment & Rating (22)

@BroLockHolmes

Print Profile

0.2mm layer, 3 walls, 15% infill

I really like it printed well but had to sand the inside alittle bit to have less drag on the can when taking it out. good job dude !!

The designer has replied

@TKB3D

glad you like it, thanks for the feed back.

@solarbike

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

I printed with PETG and it turned out great. the only thing I could complain is the cans fitts too well. you'll need a little pressure to insert the can, so removing it layer take a little effort

The designer has replied

@TKB3D

glad you like it. PLA is what it was designed on. I never tested it with PETG. thanks for the rating 😁

@SunWu_3D

Print Profile

0.2mm layer, 3 walls, 15% infill

The designer has replied

@TKB3D

thanks for the rating 😁

(Edited)

@SunWu_3D

Replying to @TKB3D :

no problem! was using PETG for this print and it turned out pretty great!

(Edited)

@TKB3D

awesome

@GreatJedi1

Print Profile

0.2mm layer, 3 walls, 15% infill

May need to print a few mm larger. Original size doesn't quite fit a 12 oz. can, at least not the one I printed.

The designer has replied

@TKB3D

thanks for the review. it's a snug fit so it doesn't slide out. but seems the can brand effects it's print.

@RPM3DINC

Print Profile

0.2mm layer, 3 walls, 15% infill

It printed very well, however upon testing, the Lid really needs to be able to be at a 90degree angle (Straight up and down) as you will hit your head with the top while trying to drink... Its about a 75-85 degree angle now.. a little refinement though and this will be a top notch model!

(Edited)

@edscreations.83

Print Profile

0.2mm layer, 3 walls, 15% infill

The designer has replied

@TKB3D

Thanks for the rating 😁

@edscreations.83

Replying to @TKB3D :

I did have a little issue when trying to assemble it. One of the legs on the lid keeps breaking when being pressed into place. I am going to have to either shrink the balls a little or increase the slant some more.