The Easy Print Planter is a self-watering planter that prints in one piece, WITHOUT supports! To use, pour water into the reservoir until the floater is 2 inches above the top of the pot. Don't forget to refill whenever the water-level floater dips below the top of the pot!
Printer Brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm
Infill:
70%
Black
Activate Water Level Floater
Simply push down lightly on the floater to break the small internal stick holding it in place, and you're good to go!