这款可调支架的结构有加强，尺寸也加大，很平稳，可以竖着放平板电脑。
The adjustable phone stand has a reinforced structure and larger dimensions, making it very stable and suitable for placing a tablet computer vertically.

安装前准备：3D打印件+螺丝、螺母、垫片
Preparation before installation: 3D printed parts + screws、nuts、washers

先把装饰条装入对应的槽里，建议用无白化或低白化的胶水粘接。
Install the inlays into the corresponding groove, and it is recommended to use glue with no or low whitening for bonding.

把垫片装入对应的槽里，建议用无白化或低白化的胶水粘接。
Install the washers into the corresponding groove, and it is recommended to use glue with no or low whitening for bonding.

往螺母涂上中强度螺纹胶（强烈建议），然后放入底座和支架的螺母槽里。Apply medium-strength threadlocker to the nut (strongly recommended), and then place it into the nut groove of the Base and Support.

将打印件按图示位置摆放，往螺丝里再套一个Ø4×Ø9的垫片，插入打印件的螺丝孔里，拧上螺丝，拧的时候可以转动底座和支架，感受阻尼的力度，合适为止。等待螺纹胶固化后，即可使用。Place the printout in the position shown in the diagram, insert a Ø4×Ø9 washers into the screw, insert it into the screw hole of the 3D printed parts, and tighten the screw. While tightening, you can rotate the base and bracket to feel the strength of the damping until it is appropriate. After the threadlocker has cured, it can be used.