数码博主们经常拍摄的手机竖立在桌面上的画面
所以制作了一个可以实现这个效果的同时,尽可能的缩小体积,防止其他角度穿帮的竖立支架
一共制作了两个版本
1.轻量版,一体打印适合批量生产,大量展示镜头适用此种,分为矮版和高版
2.三角度可调版
70,80,90度三个角度可更换
提供正常底座和加大底座
使用前的处理:塑料本身没有摩擦力,为了拍摄时不穿帮所以不能用夹具形式固定手机
1.使用双面胶、纳米胶贴住红色接触板(放心一般的胶不会残留在手机背部)
2.给底座防滑,可以贴硅胶防滑脚贴或是让胶水凝固起到防滑效果。若需要支撑的设备过重可以改成双面胶粘住桌面和支架底座
正常情况可以重复使用
建议改为100%填充为支架加重(但塑料本身质量就很轻,所以需要胶来固定)
开源文件为f3d格式
Digital content creators often capture shots of their phones standing vertically on a desk. To achieve this effect while minimizing the stand's visibility from other angles, I have designed a compact vertical phone stand.
### Two Versions
1. **Lightweight Version**:
- Suitable for mass production and extensive shot displays.
- Available in short and tall versions.
- Printed as a single piece.
2. **Adjustable Three-Angle Version**:
- Offers three replaceable angles: 70, 80, and 90 degrees.
- Comes with a standard base and an enlarged base option.
### Pre-use Preparation
Plastic itself lacks friction, so to avoid the phone slipping during filming, it cannot be clamped. Here’s how to prepare the stand for use:
1. **Secure the Contact Plate**:
- Use double-sided tape or nano adhesive to secure the red contact plate. (Don't worry, regular adhesive won't leave residue on the back of your phone.)
2. **Add Anti-Slip Features to the Base**:
- Attach silicone anti-slip pads or allow glue to set for an anti-slip effect.
- For heavier devices, you can use double-sided tape to stick the base to the table.
Under normal conditions, the stand can be reused multiple times.
### Additional Recommendations
- For added stability, consider printing the stand with 100% infill to increase weight (plastic itself is light, so adhesive is needed for fixation).
### Open Source
The design files are available in f3d format for further customization and improvement.