Intex / Bestway Pool Cover Clip by Bruno Teixeira

Bruno Teixeira

Household>Garden

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 9 walls, 100% infill

Designer

1.3 h

2 plates

4.7(6)

Open in Bambu Studio

Boost

Released

Description

This is a clip that I modeled to hold my tubular pool cover that was always falling.

The clip works on any tubular pool that uses tubes with a diameter of 50 to 55mm, such as most Intex and Bestway pools.

We recommend printing in ABS/ASA or PETG, but PLA, as long as it is white or a light color, also works.

There are 2 models:
- single clip
- double (Easier to print, as it promotes the bed adhesion. It needs to be split with pliers afterwards)

Comment & Rating (7)

@Alpineskyline

Print Profile

0.2mm layer, 9 walls, 100% infill

Other Issues:Single plate five stars Double plate 2 stars. If you want the chance of ripping a hole in your pool cover or a lot of after print deburring utilize the double plate. Printing multiple just utilize the clone/copy feature and use the single plate.

The designer has replied

@calibre12

Hi. The double model is there to help printing without warping on plates with bad adhesion. Of course the pieces may need some deburring after clipping it with a cutting plier to remove any sharp edge that may exist. I used the cheap plier that came with my printer and it left no sharp edges, but I admit that the results may vary if using some other pliers or even filaments. If the bed is good, you can just print the single one. Thanks for your feedback.