CR2032 - D Battery Shaped Button Cell Holder
Copyright Claim
CR2032 - D Battery Shaped Button Cell Holder
Boost
13
20
3
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
53 min
1 plate
Open in Bambu Studio
Boost
13
20
3
2
6
11
Released
Description
I made this CR 2032 button cell battery holder to fit inside my battery caddy in the D Battery slots
- Fits 10 CR2032 coin cell batteries
- Push the battery all the way in and it friction locks in
- Easily remove any battery
- No batteries will fall out if you tip it or roll it around
Fits in a D battery slot, I made for the battery daddy that costco or amazon sells (I assume it will fit any D battery holder, if not I can make it a smaller in diameter)
Let me know if you have any suggestions for edits on this battery dispenser
Print it laying down flat, it prints best that way, then just remove the supports with a butter knife
Comment & Rating (3)
All
Boosted
Exactly what I was looking for
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld