Filament Clip - Screwable by Leo.w8

Leo.w8

Tools>Other Tools

Print Profile(8)

All

P1S

P1P

X1 Carbon

X1E

Set x1

Designer

19 min

1 plate

4.7(9)

Set x10

Designer

1.6 h

1 plate

3.0(4)

Screw Only for dif. Colors x1

Designer

14 min

1 plate

Clip Only for dif. Colors x1

Designer

16 min

1 plate

Click to see more

Boost

177

269

Released

Description

Filament Holder

One Size fits all! a handy little quick print for all your spools!

Its a tight fit, the first time screwing it in will be a little tough. but that might bring up memories for some ;)

0.12mm layer, 2 walls, 15% infill - perfect result!

Comment & Rating (21)

@Hodzinets

Print Profile

Set x1

The idea is great, but thread is too tight, it almost impossible to screw it in.

@gregor.nitsche

Print Profile

Set x10

Printing worked fine and straight forward. There is a little problem with the screw due to Overextrusion in the thread so the first screwing is pretty hard

(Edited)

@Haxxsaw

Print Profile

Set x10

Screw does not fit well

The designer has replied

@Leo.w8

as the info say "Its a tight fit, the first time screwing it in will be a little tough." i still wanted to thank you for your absolutely unnecessary bad rating, have a wonderful day.

@Haxxsaw

Replying to @Leo.w8 :

Rated according to the results I received. It was absolutely necessary. If you are fishing for only good ratings, perhaps do not have public prints offered.

@Leo.w8

Replying to @Haxxsaw :

Interesting take you have there, you are rating based on the results you are getting - based on the print you get with the settings you set on your printer. We share here 3d Models, the rating system should be based on the 3d Model. If you feel like the result looks completely off from what i show off, then go for it, rate it 1 star - but not if you are not able to print it to perfection with the settings YOU chose on YOUR printer. but to each their own i guess, i dont need your stars. But maybe rethink your rating procedure. Might i ask tho, if it would have fit perfectly, would that be 2 stars? or is there only 1 or 5 stars for you, no inbetween?

@Kandur

Print Profile

Set x1

The designer has replied

@Leo.w8

Looking beautiful, thank you for sharing!

@eric.seifert

Print Profile

Set x1

Die Schraube löste sich ab. Ich probiere es noch mal. 😁

@SimpleSol3D

Print Profile

Set x10

Only half of them survived printing. The top of the screws often fails causing them to fall over.

@jbizall

Print Profile

Set x1

It was a little difficult to screw it all the way in the first time. I used a pair of pliers. But once you do it once, you're good, it screws freely after that. I'm not sure if the tolerances were intentionally close but I made it work. I printed in Polaroid PLA.