Simple Flat Keycap (Good for custom Keycap base)
Copyright Claim
Simple Flat Keycap (Good for custom Keycap base)
Boost
3
2
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Open in Bambu Studio
Boost
3
2
2
0
2
0
Released
Description
A simple Low-ish profile Keycap. It's my first day. Anyway I printed it with .2mm layer height and I recommend printing in PETG as I'm not sure PLA would survive long. You may have to push the cap down a little hard at first but after it clicks in place it's good to go. Surface is flat so it can serve as a base for custom keycaps.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Print came out clean.
The designer has replied
1
Reply
Thanks so much for trying it out and leaving the rating/photo! As my first published design it's super rewarding to see this!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld