Low profile motorcycle plate holder
Copyright Claim
Low profile motorcycle plate holder
Boost
0
2
0
Print Profile(0)
Add the first print profile to earn points
Boost
0
2
0
0
1
0
Released
Description
Motorcycle Plate holder
- Should work for many motorcycles [tested on a KTM 125-390 (2011-2016)]
- Low Profile
- Tested with Czech plate holder (20x16cm) Should work for any EU Plates
- Tested with 200 Km/h
- PETG or stronger filaments recomended
- Infill 50% or higher, I don't recomend anything less (even better if you make the 4 holders (circeled in the picture) 100% infill)
!!!!Do not print with PLA!!!!
Comment & Rating (0)
All
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld