Inland Filament Refill Spacer for Bambu Refill Spool
Copyright Claim
Inland Filament Refill Spacer for Bambu Refill Spool
Boost
33
66
17
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
6.5 h
1 plate
Boost
33
66
17
0
175
146
Released
Description
I purchase refills when ever I can find them at a fair price. I wanted a better spacer for Inland refills. I keyed the spacer to line up with Bambu's notch in the refill spool. I printed out of ASA and they work great for me.
I hope you find this design works well for you!
Comment & Rating (17)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
gets the job done! heads up it’s snug!
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Used the provided print profile, but reduced the amount printed just to one (I only needed one for now). That said, it was a pretty quick print! It took about an hour and a half, and fits perfectly in the Bambu Labs spool.
0
Reply
Did not work, Too snug, filament spool unwound while trying to fit, lost most of the roll
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Very nice 👍🏼 I like that chamfer on it. 👏🏼
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
doesn’t fit all inland rolls.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
wored perfect for my refill rolls. it prints 4 of them. but that's OK I guess
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
works perfect
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Worked perfectly and is currently running through my AMS.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Makes using my Microcenter refills way easier to use now.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld