Simple Caliper
Copyright Claim
Simple Caliper
Boost
16
22
17
Print Profile(1)
Painted Black Text 0.2mm layer, 2 walls, 15% infill
21 min
1 plate
Boost
16
22
17
0
101
81
Released
Description
This is a simple caliper. Print both parts separately to save time. The slider has to be printed upright, and you will need to experiment with xy-hole-compensation for a good fit.
Comment & Rating (17)
All
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
Great, but it seems. a bit too tight, installation is not smooth.
(Edited)
The designer has replied
0
Reply
if it's easy to install it'll fall off in use. You shove it on once and it stays.
(Edited)1
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
perfect quality
(Edited)
0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
Pretty accurate, just make sure to let it fully cool down on the build plate before removing. I pulled mine off too soon and warped it a little.
The designer has replied
0
Reply
When I'm feeling impatient I'll take the plate to my sink and wash with cold water. Most prints immediately release.
0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
when you need a caliper you'll be glad you can just print one
0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
perfect
0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
hat prima geklappt!
0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
very useful and fun
(Edited)0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
It worked just fine :) and its better them i thought. Really usefull
0
Reply
Very useful and accurate. A bit too tight of a fit though
0
Reply
Print Profile
Painted Black Text 0.2mm layer, 2 walls, 15% infill
Actually came in handy in a pinch!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld