Paul movie poster fridge magnet.

Measuring 65mm wide by 95mm high by 5mm deep

6 colour AMS print, using black, lemon Yellow, white blue, pine green and beigie. Prints on one AMS with a pause to swap colours at layer 41.

Start with your AMS loaded as follows

1 Black

2 Lemon Yellow

3 White

4 Blue

At the pause swap the yellow for the greem and the blue for the beige as follows

1 Black

2 Pine Green

3 White

4 Beige

This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.

NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.