The Mummy movie poster fridge magnet
Boost
15
15
8
Print Profile(2)
0.08mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
French version - 0.08mm layer, 2 walls, 15% infill
3.3 h
1 plate
Open in Bambu Studio
Boost
15
15
8
2
12
10
Released
Description
The Mummy movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, brown, orange and lemon yellow.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (8)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Simple and effective, I really like it!
I will post a French version ^^
The designer has replied
0
Reply
Nice job as usual on the translation, Thanks Allan :)
(Edited)1
Reply
Boosted
love this one. I am not able to use more than one AMS on my A1 so not able to do some of the new ones.
The designer has replied
1
Reply
Thank you! I am still trying to do a balance of 1 and 2 AMS models
Thank you for the boost :-)
1
Reply
Looks great! I will definitely be printing it, once I get the broken feeder on my AMS repaired. :)
The designer has replied
1
Reply
Thanks! I'm sorry you're having tech trouble though... That always sucks 🙁
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld