from me:

printer: Bambu labs p1s 

filament: esun pla silk

print profile: 0.8mm extra fine + outer brim

UPDATE

• 21/11/18
  correct shape and size for foolproof notch
  exported set 1S to 8S
• 19/11/18
  files names were inverted

There was no JST-XHP 6S on thingiverse so i designed a parametric model using specification from JST (google it).

These are tiny pieces to print. I had to adjust the genuine specs (pin and wire holes) over few iterations (see picture), so my printer could print it correctly with a 0.4 nozzle.

Printed example for a 4S JST-XH (see picture). If necessary i can upload a larger set like 1 to 12S ...

This design is done now, nothing to change a priori... Any feedback is appreciated.

Print Settings

• Printer brand:

Prusa

• Printer:

i3 MK3

• Rafts:

No

• Supports:

No

• Resolution:

0.2mm

• Infill:

20%

• Filament brand:

Prusa

• Filament material:

PLA

• Notes:

I used the following profil from Slic3r Prusa Edition:

• 0.20mm Fast MK3 (print settings)
• Prusa PLA (filament)

Object is printed wires side opening face to the bed.

Post-Printing

Finishing printed parts

Just trim the excess for plastic, wires side, in case Z offset is to tight, otherwise wires will be impossible to install.
Then insert, push, press the wires to fit in.