This is a slim AMS riser for the P1P/P1S/X1/X1C/X1E type model Bambu printers.

I couldn't quite find what I was looking for in the risers available, so I designed one myself.

This design allows the top glass to be slid forward until it hits the LCD screen, this is far enough to allow venting.

The parts are connected with dovetail joints, no super glue necessary but it is recommended.

The profile includes an STL for a gasket, which you could print from TPU if you wanted to seal the chamber better.

You can also glue craft felt to the top of the riser to allow for a better seal while still allowing the glass to slide.

In designing this, I ended up printing it several times, both PETG and PLA models are preforming similarly.

This AMS slim riser supports a 6mm neon type LED strip: https://a.co/d/94McIlo

The LED strip needs a 12 volt power supply: https://a.co/d/g2r83vM
The LED strip linked comes with one connector already soldered on, so no soldering necessary.