DO NOT CHANGE THE Z-HEIGHT. For ease of use, i suggest unchecking the “UNIFORM SCALE” and change X and Y Percentace only when editing size;

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Matte Marine Blue Transmission Distance: 0.5
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
PLA BambuLab Matte Ivory White Transmission Distance: 3.5
This print uses 4 unique filaments

Swap Instructions:
Start with Charcoal
At layer #11 (0.96mm) swap to Marine Blue
At layer #19 (1.6mm) swap to Ice Blue
At layer #21 (1.76mm) swap to Ivory White for the rest.