This is a simple lamp, easy to print in 2 pieces, the outer Shell and an inner shade.

210 mm Height - 85 mm width

It was made for an E14 fassung(socket) with a threaded insert to screw in the bulb socket . The bulb is a low wattage soft white.

The filaments used were an ERYONE Matte PLA Filament black and Prusament Vanilla White for the shade. No supports are required during printing.

The electrical parts are listed cheaply available.

The electrical parts are pictured and cheaply available.

The fassung-lamp socket ( e14-28 mm):
https://www.amazon.de/dp/B097K4YNL9

The electrical cable and switch:
https://www.amazon.de/dp/B002DAOX58

The E14 Bulb used here:
https://www.amazon.de/dp/B0B5MPL9MX

The slicer settings for the outer shell:

.20 mm Standard and Generic PLA

(All standard settings and speeds)

Filament: Eryone Matte Black PLA

The slicer settings for the Bullet Shade:

.16 mm High Quality and Generic PLA
Infill % - 30 , Gyroid
Wall Loops - 8
Top Shell - 8
Bottom Shell - 6
Outer Wall Speed - 60 mm/s
Inner Wall - 150 mm/s

Seam Position- Random

Filament- Prusament Vanilla White