3 Device Holder for HoneyComb Storage Wall
Fits walls with the top of the honeycomb being horizontal

supports on the honeycomb pieces I used auto tree in orca slicer and they where fantastic bambu studios auto tree doesn't extend to the top piece it could probably print without supports but your mileage will vary and its so light at 35g with supports.

fits devices up to 80mm wide and 20mm deep aka my pixel 8 fits perfectly and my other devices fit with room to spare.

When installing make sure to press on the spot where the honeycomb pieces are and not the front of the model to avoid breaking it.

walls are 1.2mm thick all around including the bottom. this cut down on infill and solid fill while keeping it strong.

I used:
0.40 nozzle
2 walls
15% gyroid infill