Aurebesh Aurek-Besh Aurabesh Translation ID Card by ShortyTHEone

ShortyTHEone

Props & Cosplays>Other Props & Cosplays

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2 Aurebesh ID

Designer

2.3 h

1 plate

5.0(5)

0.4mm Nozzle, 0.2mm layer, 2 walls, 15% infill

30 min

1 plate

5.0(3)

Boost

Released

Description

I'm a big Fan of Star Wars, but when it comes to “reading Aurebesh”, i always struggle to find the Translation for each letter.

so i figured i design a small card (7cm x 11cm / 2 ¾" x 4 1/3 ") with all the letters and punctuation marks to help me translate words easier.

the design is a bit futuristic, but simple, to resemble a bit more the star wars theme, then just being a simple rectangluar Card.

Comment & Rating (19)

@berndE

Printed with 0,4 nozzle. 0,08 High Quality Black and yellow PLA. ± 1 hour Thank you for your work.

The designer has replied

@ShortyTHEone

nice print, thanks for sharing your result :)

@pumpkin20303

Boosted

Print Profile

0.2 Aurebesh ID

Worked great with 0.4 nozzle too. Thankyou!

The designer has replied

@ShortyTHEone

nice, good to know, didn’t expected it to come out that good with a 0.4 nozzle. thanks for sharing your result 👍🏻

@gloriouslyawkwd

Boosted

Flawless print; eSun PLA+ w/ the 0.2mm nozzle, 0.10 layer height, a little over 8 hours to print. Handy for visits to Galaxy's Edge at Walt Disney World. :-) May print more of these (likely at 0.4 mm) to give away when I'm in the parks.

(Edited)

@TECS

Print Profile

0.4mm Nozzle, 0.2mm layer, 2 walls, 15% infill

This is what I was looking for. I made one based off it for Mandalorian.

@CURS3D

Print Profile

0.2 Aurebesh ID

had a slight bed adhesion issue, but I'm chalking it up to just got my PEI plate and things are hit or miss on sticking so far

The designer has replied

@ShortyTHEone

try washing your plate with dawn dish soap and use a lint-free towel or anything to dry it. then try to wipe it with high proof IPA (I use 99%) to get of any fingerprint if still there.

@CURS3D

Replying to @ShortyTHEone :

I will try higher IPA that I have for my resin printer, I take a shot every 2 weeks so they always send me alcohol wipes and thats what I've been using. Just discovered they're only 70%

(Edited)

@ShortyTHEone

Replying to @CURS3D :

sounds like a plan, hope it workes for you

@farpetrad

Wanted to print this but bambu studio shows the entire thing with one filament even though it shows a wipe/purge tower for two colors. Changing all of the filaments in your profile did not change this at all.

The designer has replied

@ShortyTHEone

I’ll take a look at it as soon as I am at home. maybe that’s because there is just a color swap at specific layer height, but I will double check that. thank you

@ShortyTHEone

just downloaded the file and tested it, if you press "Slice plate" the second color should appear. I think that is because its just a filament swap and not a painted multicolor print.