I set about designing another cable channel that is narrower and can also be printed with either two grooves for cables with a diameter of approx. 4.5 mm (e.g. standard network cables) or without them.
This is just the complete cable ducts, the part for the switch is not included as it is specifically for the system seen here.
Proven click mechanism with good and sufficient hold
The standard dimensions are 20cm x 2.4cm x 2.6cm (length x width x height), but can be edited in the slicer. There are two screw holes with a diameter of 4 mm.
I hope it helps and you can benefit from it.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.