Working Poop cannon (print-in-place) Remixed by Makkuro

Remixed by

Makkuro

Toys & Games>Other Toys & Games

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.2 h

1 plate

4.7(3)

multicolor 0.2mm layer, 2 walls, 15% infill

Designer

8.6 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Please rate the print profiles - It would help tremendously.

This is a working poop cannon. It has a spring to shoot poops. Use the hinge to aim precisely.

Print it as a toy for your kids, grandkids, or present it to friends as a gift.
Check out the original print-in-place cannon as well!

Printing

Print it without supports and as oriented in the STL. (The cannon and front of the carriage should point down towards the print bed.)
The cannon is fully print-in-place: No assembly required, just remove the cannon from the print bed and fire away! (The hinge and piston might need some initial movement to get going.)
The cannon is designed for easy printing, so bed adhesion should not be an issue.
The spring (inside the cannon) is 3D printed, and works well also if you print in PLA. There is a hinge included for aiming. It might need some initial movement to get going.

Videos featuring this model

Thanks to lostintech to feature this model in his youtube channel!
Thanks to +Ultra for his TikTok video of the cannon.
Thanks to MakerTeam for their print video on youtube.

Other models

I uploaded a print-in-place spring-driven model, the slot machine! Have a look :)

Comment & Rating (12)

@thekraftydragon

Print Profile

0.2mm layer, 2 walls, 15% infill

don’t tilt for aiming

The designer has replied

@Makkuro

Thanks for the review. What slicer did you use? Both prusaslicer and bambuslicer should be fine

@thekraftydragon

Replying to @Makkuro :

i used bambu, i even sized up a bit (5%) with no success.

@Makkuro

Replying to @thekraftydragon :

OK, you can try: - use a matte filament, not shiny - calibrate e-steps (but bambu should be fine there) - lower the filament temperature - put a little force on it after it cooled and try to tilt it to break it free - but careful, sometimes this breaks it