This is a Hueforge filament painting of the the psychotic psychotherapist, Harley Quinn. This is companion piece to The Joker painting I released earlier found HERE. The frame for all of my, and probably the vast majority of 200x200 prints is HERE.

*

This is a simple 5 color print that can easily be done by people with or without AMS units. If you have an A1 mini or any other printer with a bed smaller than the capacity to print 200x200 you can use the slicer to scale the model in the correct profile for your multi color setup just make sure NOT TO SCALE THE Z dimension.

IMPORTANT: READ BEFORE PRINTING - SUPER IMPORTANT THIS TIME

*

I have uploaded two 3MF profiles. One for people with AMS unit(s), one for people with NO AMS.

*

To print with 1 AMS you need to swap out AMS slot [2]/(Color [2]) with Color [5] when the blue gray [Color 2] has completed and fully retracted. The black is used twice in this one so make sure don't swap that out. Once the third color starts printing just load the new spool. Note the AMS will not feed the spool like it does pre print but as long as you have fed 3-4 inches in there and the light goes on it will feed as normal when it swaps back to the last color in AMS slot [2].

*

If you have two AMS units when you hit print just assign the 5th color (red) to the correct slot in you second AMS.

*

To print with NO AMS unit you just need to do manual filaments swaps every color. The 3MF is set to pause at the correct layer heights. At each pause load the next filament color in order by following your unload/load procedure for your particular printer, then hit resume. Repeat until complete. This will be once per color over the entire painting. You have a decent amount of time between swaps, and is actually harder to mess up because it pauses unlike when using the AMS.

*

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. There are some recommended speed changes in my 3MF files and a layer height modifier to print the first 0.64 mm @ 0.16 mm layer height to speed up the print as there is no blending on those layers.

*

Like all of my models this is strictly for personal use. The photo attached is the printed model and frame.

*

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
*

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA PolyLite Wine Red Transmission Distance: 1

This print uses 5 unique filaments

*

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Gray
At layer #14 (1.2mm) swap to Jade White
At layer #22 (1.84mm) swap to Black
At layer #24 (2mm) swap to Wine Red for the rest.