Cable management enthusiasts, THIS one's for you!
Tired of your Extruder-cable & PTFE-tubing going separate ways?
Here's a quick and easy solution.
*(2) Clips work just fine but (4) look waaaay better =)
** I recommend the PTFE-tubing to go behind the Cable - I looks cleaner IMO.
¡¡Attention!!
The clips have different-sized openings! The smaller one is for the PTFE-tubing.
As the difference is minimal and might not be obvious for everyone - I placed the smaller opening on the left hand side of the build-plate.
Mark them before removing, remember, measure or try to spot the difference. But in case you mount them the other way around..
no worries.. they will fit as well - just not as intended ^^